LPC2106FBD48/01,15

The LPC2106FBD48/01 is a 16-/32-bit Microcontroller based on ARM7TDMI-S CPU with real-time emulation and embedded trace support. A 128-bit wide memory interface and an unique accelerator architecture enable 32-bit code execution at maximum clock rate. For critical code size applications, the alternative 16-bit Thumb mode reduces code by more than 30 % with minimal performance penalty. The device incorporates 128kB embedded high speed flash, 64kB on-chip SRAM, three 32-bit timers PWM channels and 32 general-purpose I/O pins.

• In-system programming (ISP) and In-application programming (IAP)
• Vectored interrupt controller with configurable priorities and vector addresses
• Embedded trace macrocell enables non-intrusive high speed real-time tracing of instruction execution
• Multiple serial interfaces including two UARTs (16C550), fast I2C-bus (400 Kbit/s) and SPI
• Two 32-bit timers (7 capture/compare channels)
• PWM unit (6 outputs)
• Real time clock and watchdog
• Up to thirty-two 5V tolerant general purpose I/O pins
• 60MHz Maximum CPU clock available from programmable on-chip phase-locked loop
• The on-chip crystal oscillator should have an operating range of 1MHz to 25MHz
• Two low power modes, Idle and power-down
• Processor wake-up from power-down mode via external interrupt
• Individual enable/disable of peripheral functions for power optimization
• Fast GPIO port enables port pin toggling up to 3.5 times faster than the original device
• UART 0/1 include fractional baud rate generator, autobauding capabilities & handshake flow-control
• Buffered SSP serial controller supporting SPI, 4-wire SSI and microwire formats
• SPI programmable data length and master mode enhancement
• Diversified code read protection (CRP)
• General purpose timers can operate as external event counters

Avertissements

Market demand for this product has caused an extension in leadtimes. Delivery dates may fluctuate. Product exempt from discounts.